ATX QFOT1310 Specifications download pdf (Page 20)

CHAPTER 8: SNMP MANAGEMENT

8-2 Q-Series

Optical – QFOT1310 Series Broadcast Transmitter – Installation & Operation Manual

NOTE: • All commands will be uppercase, so the lowercase or uppercase in commands are the same.

• The device only support one TELNET session at the same time.

• The device will disconnect the TELNET session when it is in idle for 5 minutes

• The user can close the TELNET session in two manners:

1) Input the “quit” command;

2) Either ctrl-x or ctrl-c is OK to close this session

• If the TELNET session was closed abnormally, user may wait for 5 minutes to reconnect the device with TELNET

8.2.2. Console Management

QFOT1310-S transmitter provides console management with RS232 port. The RS232 interface is:

NOTE: • Open the Hyper Terminal of the computer and set the COM port parameter as above

• Press Carriage Return 3 times to enter into the user and password prompt window

• Input the username “admin” and password “12345”

• All commands listed in 7.2.1 are accepted

8.2.3. Parameters in SNMP

SNMP software wtih transmitter MIB can read the parameters from QFOT1310-S. The following are examples of parameters

without loading transmitter MIB.

Commands Parameter Description Appendix

Show / Show basic information

Set Model “xxxxxxx”

Model

Set the Model

View the Model

When setting the model, the string must

include quotation mark, and the max string

length is 12

Set Location “xxxxxx”

Location

Set the location of the device

View the location

When setting the location string, the string

must include quotation mark, and the max

length is 12

Reboot / Reboot the device

Item Value

Interface RS232

Type DB9-Female

Rate 9600bps

Data Bit 8

Stop Bit 1

Parity None

Data Flow Control None

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 29 30

Comments to this Manuals

No comments

ATX QFOT1310 Specifications Page 20

Comments to this Manuals