CHAPTER 6: FUNCTION GUIDE
6-2 Q-Series
®
Optical – QFOT1310 Series Broadcast Transmitter – Installation & Operation Manual
9 Optical Signal Output: Optical signal output port, SC/APC, or optional FC/APC connector. There are invisible laser
emissions from Fiber output when laser is active!
*It would be dangerous to point this port toward the human body especially eyes when equipment is
energized!
10 RS-232 Standard Network Management Port (optional): Use for connecting equipment with RS-232 port in
network management server.
11 Network Management Indicator
12 RS-485 Standard Network Management Port (optional): Use for connecting equipment with RS-485 port on
network management server.
13 LAN Network Management Port: Use for connecting transmitter with Ethernet-based SNMP network management
server. (Contact factory for this option)
14 Power In: AC power connection.
15 Fuse: AC fuse
16 AC Power Switch: Turn ON or turn OFF the power.
17 Case Grounding Nut: Provided for optionally connecting the transmitter to ground.
6.3. ParameterDisplay
6.3.1. TurningOnPowerDisplay
When rst turning on the power, the VFD will display “Initialize…” for 2 seconds and the buzzer will briey tweet one
time indicating that the transmitter has initialized successfully.
6.3.2. StatusDisplay
After the transmitter has been powered ON and initialized, pressing the UP or DOWN button on the front panel will scroll the
VFD to display in turn the following:
1) “Welcome to ATX”: trademark
2) “AGC Status”: press “Enter” will switch to “MGC Status”, second “Enter” will go back to AGC
3) “S/N: xxxx-xx-xxxx”: equipment series number
4) “MOD LEVEL= XXdBmV”: modulating level value
5) “AGC ATT-XXdB”: attenuation value at “AGC Status”
6) “INPUT RF=XXdBmV”: RF input level
7) “BIAS-XX mA”: bias current of the laser
8) “TEMP=XX.X °C”: internal temperature value of the laser
9) “POWER=XX.X mW”: output power, unit mW
10) “QFOT1310-XX-S”: module name, S indicated built-in SNMP Interface Board
6.4. Alarm Indication
DisplayMessage Alarm Status SystemIndication
Warning...!!! Input RF is low Input RF is too low • Status indicator red light ashes
Warning...!!! Input RF is high Input RF is too high • Status indicator red light ashes
Comments to this Manuals